化粪池工艺原理 |
添加时间:2019/2/22 9:13:02 浏览次数: |
化粪池工艺原理 Principle of septic tank technology 化粪池是一种利用沉淀和厌氧发酵的原理,去除生活污水中悬浮性有机物的处理设施, 属于初级的过渡性生活处理构筑物。生活污水中含有大量粪便、纸屑、病原虫...悬浮物固体浓度为 100~350mg/L,有机物浓度CODCr 在100~400mg/L之间,其中悬浮性的有机物浓度BOD5为50~200mg/L。污水进入化粪池经过12~24h的沉淀,可去除50%~60%的悬浮物。沉淀下来的污泥经过3个月以上的厌氧发酵分解,使污泥中的有机物分解成稳定的无机物,易腐败的生污泥转化为稳定的熟污泥,改变了污泥的结构,降低了污泥的含水率。定期将污泥清掏外运,填埋或用作肥料。要求:化粪池 的沉淀部分和腐化部分的计算容积,应按《建筑给水排水设计规范》(GB50015-2003)第4.8.4~4.8.7条确定。污水在化粪池中停留时间宜采用12h~36h。对于无污泥处置的污水处理系统,化粪池容积还应包括贮存污泥的容积。 The septic tank is a treatment facility for removing suspended organic matter from domestic sewage by using the principles of sedimentation and anaerobic fermentation. It belongs to the primary transitional life treatment structure. Domestic sewage contains a large number of feces, paper scraps, pathogens.... The solid concentration of suspended matter is 100-350 mg/L, the organic concentration of CODCr is 100-400 mg/L, and the suspended organic concentration of BOD5 is 50-200 mg/L. Sewage entering septic tank can remove 50%~60% of suspended solids after 12~24 hours of precipitation. Sedimented sludge is decomposed by anaerobic fermentation for more than three months, which makes the organic matter in sludge decompose into stable inorganic matter. The easily corrupted raw sludge is transformed into stable mature sludge, which changes the structure of sludge and reduces the water content of sludge. Sludge is regularly removed and transported, landfilled or used as fertilizer. Requirements: The calculated volumes of sediment and decay parts of septic tanks should be determined in accordance with Article 4.8.4-4.8.7 of the Code for Design of Building Water Supply and Drainage (GB50015-2003). The residence time of sewage in septic tank should be 12h~36h. For sewage treatment systems without sludge disposal, the volume of septic tank should also include the volume of stored sludge. |
上一页 化粪池模具的发展历程 |
下一页 化粪池工作原理与作用 |
Copyright © 技术支持:遨游网络